Command Reference Guide

DiffServ Class Commands
CLI Command Reference
September 2014 Page 631
HP Moonshot Switch Module CLI Command Reference
no match class-map
This command removes from the specified class definition the set of match conditions defined for another
class. The
refclassname is the name of an existing DiffServ class whose match conditions are being referenced
by the specified class definition.
match cos
This command adds to the specified class definition a match condition for the Class of Service value (the only
tag in a single tagged packet or the first or outer 802.1Q tag of a double VLAN tagged packet). The value may
be from 0 to 7.
Note:
•The parameters
refclassname and class-map-name can not be the same.
• Only one other class may be referenced by a class.
• Any attempts to delete the
refclassname class while the class is still referenced by any class-map-
name fails.
• The combined match criteria of
class-map-name and refclassname must be an allowed
combination based on the class type.
• Any subsequent changes to the
refclassname class match criteria must maintain this validity, or
the change attempt fails.
• The total number of class rules formed by the complete reference class chain (including both
predecessor and successor classes) must not exceed 416. In some cases, each removal of a refclass
rule reduces the maximum number of available rules in the class definition by one.
Format
no match class-map refclassname
Mode Class-Map Config
Ipv6-Class-Map Config
Default none
Format
match cos 0-7
Mode Class-Map Config
Ipv6-Class-Map Config