Command Reference Guide

DiffServ Service Commands
CLI Command Reference
September 2014 Page 643
HP Moonshot Switch Module CLI Command Reference
DiffServ Service Commands
Use the DiffServ service commands to assign a DiffServ traffic conditioning policy, which you specified by using
the policy commands, to an interface in the incoming direction
The service commands attach a defined policy to a directional interface. You can assign only one policy at any
one time to an interface in the inbound direction. DiffServ is not used in the outbound direction.
This set of commands consists of service addition/removal.
The CLI command root is
service-policy.
service-policy
This command attaches a policy to an interface in the inbound direction as indicated by the in parameter, or
the outbound direction as indicated by the
out parameter, respectively. The policyname parameter is the name
of an existing DiffServ policy. This command causes a service to create a reference to the policy.
Note: This command effectively enables DiffServ on an interface in the inbound direction. There is no
separate interface administrative 'mode' command for DiffServ.
Note: This command fails if any attributes within the policy definition exceed the capabilities of the
interface. Once a policy is successfully attached to an interface, any attempt to change the policy
definition, that would result in a violation of the interface capabilities, causes the policy change
attempt to fail.
Format
service-policy {in|out} policymapname
Modes • Global Config
•Interface Config
Note: Each interface can have one policy attached.