Command Reference Guide

Telnet Commands
CLI Command Reference
September 2014 Page 65
HP Moonshot Switch Module CLI Command Reference
no telnetcon maxsessions
This command sets the maximum number of Telnet connection sessions that can be established to the default
value.
telnetcon timeout
This command sets the Telnet connection session timeout value, in minutes. A session is active as long as the
session has not been idle for the value set. The time is a decimal value from 1 to 160.
no telnetcon timeout
This command sets the Telnet connection session timeout value to the default.
Format
no telnetcon maxsessions
Mode Privileged EXEC
Note: When you change the timeout value, the new value is applied to all active and inactive sessions
immediately. Any sessions that have been idle longer than the new timeout value are disconnected
immediately.
Default 5
Format
telnetcon timeout 1-160
Mode Privileged EXEC
Note: Changing the timeout value for active sessions does not become effective until the session is
accessed again. Also, any keystroke activates the new timeout duration.
Format
no telnetcon timeout
Mode Privileged EXEC