Command Reference Guide

DiffServ Show Commands
CLI Command Reference
September 2014 Page 650
HP Moonshot Switch Module CLI Command Reference
show policy-map interface
This command displays policy-oriented statistics information for the specified interface and direction. The
unit/slot/port parameter specifies a valid interface for the system. Instead of unit/slot/port, lag lag-intf-
num can be used as an alternate way to specify the LAG interface. lag lag-intf-num can also be used to specify
the LAG interface where
lag-intf-num is the LAG port number.
The following information is repeated for each class instance within this policy:
Note: This command is only allowed while the DiffServ administrative mode is enabled.
Format
show policy-map interface unit/slot/port { in| out}
Mode Privileged EXEC
Term Definition
Interface unit/slot/port
Direction The traffic direction of this interface service.
Operational
Status
The current operational status of this DiffServ service interface.
Policy Name The name of the policy attached to the interface in the indicated direction.
Term Definition
Class Name The name of this class instance.
In Offered
Packets
The total number of octets offered to all class instances in this service policy before their
defined DiffServ treatment is applied. This is the overall count per-interface, per-direction.
In Discarded
Packets
A count of the packets discarded for this class instance for any reason due to DiffServ
treatment of the traffic class.