Command Reference Guide

IP Access Control List Commands
CLI Command Reference
September 2014 Page 668
HP Moonshot Switch Module CLI Command Reference
no ip access-group
This command removes a specified IP ACL from an interface.
Example: The following shows an example of the command.
(Routing)(Config)#no ip access-group ip1 control-plane
acl-trapflags
This command enables the ACL trap mode.
no acl-trapflags
This command disables the ACL trap mode.
show ip access-lists
Use this command to view summary information about all IP ACLs configured on the switch. To view more
detailed information about a specific access list, specify the ACL number or name that is used to identify the IP
ACL. The rate-limit attribute displays committed rate and committed burst size.
Default none
Format
no ip access-group {accesslistnumber|name} {{control-plane|in|out}|vlan vlan-id
{in|out}}
Mode •Interface Config
• Global Config
Default disabled
Format
acl-trapflags
Mode Global Config
Format
no acl-trapflags
Mode Global Config
Format
show ip access-lists [accesslistnumber | name]
Mode Privileged EXEC
Term Definition
ACL ID/Name Identifies the configured ACL number or name.
Rules Identifies the number of rules configured for the ACL.
Direction Shows whether the ACL is applied to traffic coming into the interface (ingress)
or leaving the interface (egress).