Command Reference Guide

Secure Shell Commands
CLI Command Reference
September 2014 Page 67
HP Moonshot Switch Module CLI Command Reference
Secure Shell Commands
This section describes the commands you use to configure Secure Shell (SSH) access to the switch. Use SSH to
access the switch from a remote management host.
ip ssh
Use this command to enable SSH access to the system. (This command is the short form of the ip ssh server
enable
command.)
ip ssh protocol
This command is used to set or remove protocol levels (or versions) for SSH. Either SSH1 (1), SSH2 (2), or both
SSH 1 and SSH 2 (1 and 2) can be set.
ip ssh server enable
This command enables the IP secure shell server. No new SSH connections are allowed, but the existing SSH
connections continue to work until timed-out or logged-out.
no ip ssh server enable
This command disables the IP secure shell server.
Note: The system allows a maximum of 5 SSH sessions.
Default enabled
Format
ip ssh
Mode Privileged EXEC
Default 2
Format
ip ssh protocol [1] [2]
Mode Privileged EXEC
Default enabled
Format
ip ssh server enable
Mode Privileged EXEC
Format
no ip ssh server enable
Mode Privileged EXEC