Command Reference Guide

IP Access Control List Commands
CLI Command Reference
September 2014 Page 670
HP Moonshot Switch Module CLI Command Reference
Rule Number: 1
Action......................................... permit
Match All...................................... FALSE
Protocol....................................... 1(icmp)
Committed Rate................................. 32
Committed Burst Size........................... 16
show access-lists
This command displays IP ACLs, IPv6 ACLs, and MAC access control lists information for a designated interface
and direction. Instead of
unit/slot/port, lag lag-intf-num can be used as an alternate way to specify the LAG
interface.
lag lag-intf-num can also be used to specify the LAG interface where lag-intf-num is the LAG port
number.Use the control-plane keyword to display the ACLs applied on the CPU port.
Example: The following shows an example of the command.
(Routing) #show access-lists interface control-plane
ACL Type ACL ID Sequence Number
-------- ------------------------------- ---------------
IPv6 ip61 1
Format
show access-lists interface {unit/slot/port in|out | control-plane}
Mode Privileged EXEC
Term Definition
ACL Type Type of access list (IP, IPv6, or MAC).
ACL ID Access List name for a MAC or IPv6 access list or the numeric identifier for an IP access list.
Sequence
Number
An optional sequence number may be specified to indicate the order of this access list
relative to other access lists already assigned to this interface and direction. A lower
number indicates higher precedence order. If a sequence number is already in use for this
interface and direction, the specified access list replaces the currently attached access list
using that sequence number. If the sequence number is not specified by the user, a
sequence number that is one greater than the highest sequence number currently in use
for this interface and direction is used. Valid range is (1 to 4294967295).
in|out • in – Display Access List information for a particular interface and the in direction.
• out – Display Access List information for a particular interface and the out direction.