Command Reference Guide

IPv6 Access Control List Commands
CLI Command Reference
September 2014 Page 675
HP Moonshot Switch Module CLI Command Reference
show ipv6 access-lists
This command displays an IPv6 access list and all of the rules that are defined for the IPv6 ACL. Use the [name]
parameter to identify a specific IPv6 ACL to display. The rate-limit attribute displays committed rate and
committed burst size.
Example: The following shows example CLI display output for the command.
(Routing) #show ipv6 access-lists ip61
ACL Name: ip61
Outbound Interface(s): control-plane
Rule Number: 1
Action......................................... permit
Format
show ipv6 access-lists [name]
Mode Privileged EXEC
Note: Only the access list fields that you configure are displayed. Thus, the command output varies
based on the match criteria configured within the rules of an ACL.
Term Definition
Rule Number The ordered rule number identifier defined within the IPv6 ACL.
Action The action associated with each rule. The possible values are Permit or Deny.
Match All Indicates whether this access list applies to every packet. Possible values are
True or False.
Protocol The protocol to filter for this rule.
Committed Rate The committed rate defined by the rate-limit attribute.
Committed Burst Size The committed burst size defined by the rate-limit attribute.
Source IP Address The source IP address for this rule.
Source L4 Port Keyword The source port for this rule.
Destination IP Address The destination IP address for this rule.
Destination L4 Port Keyword The destination port for this rule.
IP DSCP The value specified for IP DSCP.
Flow Label The value specified for IPv6 Flow Label.
Log Displays when you enable logging for the rule.
Assign Queue The queue identifier to which packets matching this rule are assigned.
Mirror Interface The
unit/slot/port to which packets matching this rule are copied.
Redirect Interface The
unit/slot/port to which packets matching this rule are forwarded.
Time Range Name Displays the name of the time-range if the IPv6 ACL rule has referenced a time
range.
Rule Status Status (Active/Inactive) of the IPv6 ACL rule.