Command Reference Guide

Log Message Information
CLI Command Reference
September 2014 Page 686
HP Moonshot Switch Module CLI Command Reference
Section 9: Log Message Information
This chapter lists common log messages that are provided by HP Moonshot Switch Module, along with
information regarding the cause of each message. There is no specific action that can be taken per message.
When there is a problem being diagnosed, a set of these messages in the event log, along with an
understanding of the system configuration and details of the problem will assist HP in determining the root
cause of such a problem. The most recent log messages are displayed first.
The Log Messages chapter includes the following sections:
• “Core” on page 686
• “Utilities” on page 688
• “Management” on page 692
• “Switching” on page 694
• “QoS” on page 701
• “Routing” on page 702
• “Stacking” on page 704
• “Technologies” on page 704
• “O/S Support” on page 706
Core
Note: This section is not a complete list of all syslog messages.
Table 15: BSP Log Messages
Component Message Cause
BSP Event(0xaaaaaaaa) Switch has restarted.
BSP Starting code... BSP initialization complete, starting the HP
Moonshot Switch Module application.
Table 16: NIM Log Messages
Component Message Cause
NIM NIM: L7_ATTACH out of order for interface
unit x slot x port x
Interface creation out of order.
NIM NIM: Failed to find interface at unit x slot x
port x for event(x)
There is no mapping between the USP and
Interface number.