Command Reference Guide

Switching
CLI Command Reference
September 2014 Page 694
HP Moonshot Switch Module CLI Command Reference
Switching
Table 34: Protected Ports Log Messages
Component Message Cause
Protected Ports Protected Port: failed to save configuration This appears when the protected port
configuration cannot be saved.
Protected Ports protectedPortCnfgrInitPhase1Process:
Unable to create r/w lock for protected Port
This appears when protectedPortCfgRWLock
Fails.
Protected Ports protectedPortCnfgrInitPhase2Process:
Unable to register for VLAN change callback
This appears when nimRegisterIntfChange
with VLAN fails.
Protected Ports Cannot add interface xxx to group yyy This appears when an interface could not be
added to a particular group.
Protected Ports unable to set protected port group This appears when a dtl call fails to add
interface mask at the driver level.
Protected Ports Cannot delete interface xxx from group yyy This appears when a dtl call to delete an
interface from a group fails.
Protected Ports Cannot update group YYY after deleting
interface XXX
This message appears when an update group
for a interface deletion fails.
Protected Ports Received an interface change callback while
not ready to receive it
This appears when an interface change call
back has come before the protected port
component is ready.
Table 35: IP Subnet VLANS Log Messages
Component Message Cause
IP subnet VLANs ERROR vlanIpSubnetSubnetValid:Invalid
subnet
This occurs when an invalid pair of subnet
and netmask has come from the CLI.
IP subnet VLANs IP Subnet Vlans: failed to save configuration This message appears when save
configuration of subnet vlans failed.
IP subnet VLANs vlanIpSubnetCnfgrInitPhase1Process:
Unable to create r/w lock for vlanIpSubnet
This appears when a read/write lock
creations fails.
IP subnet VLANs vlanIpSubnetCnfgrInitPhase2Process:
Unable to register for VLAN change callback
This appears when this component unable to
register for vlan change notifications.
IP subnet VLANs vlanIpSubnetCnfgrFiniPhase1Process: could
not delete avl semaphore
This appears when a semaphore deletion of
this component fails.
IP subnet VLANs vlanIpSubnetDtlVlanCreate: Failed This appears when a dtl call fails to add an
entry into the table.
IP subnet VLANs vlanIpSubnetSubnetDeleteApply: Failed This appears when a dtl fails to delete an
entry from the table.
IP subnet VLANs vlanIpSubnetVlanChangeCallback: Failed to
add an Entry
This appears when a dtl fails to add an entry
for a vlan add notify event.
IP subnet VLANs vlanIpSubnetVlanChangeCallback: Failed to
delete an Entry
This appears when a dtl fails to delete an
entry for an vlan delete notify event.