Command Reference Guide

Switching
CLI Command Reference
September 2014 Page 695
HP Moonshot Switch Module CLI Command Reference
Table 36: Mac-based VLANs Log Messages
Component Message Cause
MAC based
VLANs
MAC VLANs: Failed to save configuration This message appears when save
configuration of Mac vlans failed.
MAC based
VLANs
vlanMacCnfgrInitPhase1Process: Unable to
create r/w lock for vlanMac
This appears when a read/write lock
creations fails.
MAC based
VLANs
Unable to register for VLAN change callback This appears when this component unable to
register for vlan change notifications.
MAC based
VLANs
vlanMacCnfgrFiniPhase1Process: could not
delete avl semaphore
This appears when a semaphore deletion of
this component fails.
MAC based
VLANs
vlanMacAddApply: Failed to add an entry This appears when a dtl call fails to add an
entry into the table.
MAC based
VLANs
vlanMacDeleteApply: Unable to delete an
Entry
This appears when a dtl fails to delete an
entry from the table.
MAC based
VLANs
vlanMacVlanChangeCallback: Failed to add
an entry
This appears when a dtl fails to add an entry
for a vlan add notify event.
MAC based
VLANs
vlanMacVlanChangeCallback: Failed to
delete an entry
This appears when a dtl fails to delete an
entry for an vlan delete notify event.
Table 37: 802.1X Log Messages
Component Message Cause
802.1X function: Failed calling dot1xIssueCmd 802.1X message queue is full.
802.1X function: EAP message not received from
server
RADIUS server did not send required EAP
message.
802.1X function: Out of System buffers 802.1X cannot process/transmit message
due to lack of internal buffers.
802.1X function: could not set state to authorized/
unauthorized, intf xxx
DTL call failed setting authorization state of
the port.
802.1X dot1xApplyConfigData: Unable to enable/
disable dot1x in driver
DTL call failed enabling/disabling 802.1X.
802.1X dot1xSendRespToServer:
dot1xRadiusAccessRequestSend failed
Failed sending message to RADIUS server.
802.1X dot1xRadiusAcceptProcess: error calling
radiusAccountingStart, ifIndex = xxx
Failed sending accounting start to RADIUS
server.
802.1X function: failed sending terminate cause, intf
xxx
Failed sending accounting stop to RADIUS
server.