Command Reference Guide

Switching
CLI Command Reference
September 2014 Page 696
HP Moonshot Switch Module CLI Command Reference
Table 38: IGMP Snooping Log Messages
Component Message Cause
IGMP Snooping function: osapiMessageSend failed IGMP Snooping message queue is full.
IGMP Snooping Failed to set global igmp snooping mode to
xxx
Failed to set global IGMP Snooping mode
due to message queue being full.
IGMP Snooping Failed to set igmp snooping mode xxx for
interface yyy
Failed to set interface IGMP Snooping mode
due to message queue being full.
IGMP Snooping Failed to set igmp mrouter mode xxx for
interface yyy
Failed to set interface multicast router mode
due to IGMP Snooping message queue being
full.
IGMP Snooping Failed to set igmp snooping mode xxx for
vlan yyy
Failed to set VLAN IGM Snooping mode due
to message queue being full.
IGMP Snooping Failed to set igmp mrouter mode%d for
interface xxx on Vlan yyy
Failed to set VLAN multicast router mode
due to IGMP Snooping message queue being
full.
IGMP Snooping snoopCnfgrInitPhase1Process: Error
allocating small buffers
Could not allocate buffers for small IGMP
packets.
IGMP Snooping snoopCnfgrInitPhase1Process: Error
allocating large buffers
Could not allocate buffers for large IGMP
packets.
Table 39: GARP/GVRP/GMRP Log Messages
Component Message Cause
GARP/GVRP/
GMRP
garpSpanState, garpIfStateChange,
GarpIssueCmd, garpDot1sChangeCallBack,
garpApiCnfgrCommand,
garpLeaveAllTimerCallback,
garpTimerCallback: QUEUE SEND FAILURE:
The garpQueue is full, logs specifics of the
message content like internal interface
number, type of message, etc.
GARP/GVRP/
GMRP
GarpSendPDU: QUEUE SEND FAILURE The garpPduQueue is full, logs specific of the
GPDU, internal interface number, vlan id,
buffer handle, etc.
GARP/GVRP/
GMRP
garpMapIntfIsConfigurable,
gmrpMapIntfIsConfigurable: Error accessing
GARP/GMRP config data for interface %d in
garpMapIntfIsConfigurable.
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no pre-
configuration.
GARP/GVRP/
GMRP
garpTraceMsgQueueUsage: garpQueue
usage has exceeded fifty/eighty/ninety
percent
Traces the build up of message queue.
Helpful in determining the load on GARP.
GARP/GVRP/
GMRP
gid_destroy_port: Error Removing port %d
registration for vlan-mac %d -
%02X:%02X:%02X:%02X:%02X:%02X
Mismatch between the gmd (gmrp
database) and MFDB.
GARP/GVRP/
GMRP
gmd_create_entry: GMRP failure adding
MFDB entry: vlan %d and address %s
MFDB table is full.