Command Reference Guide

Switching
CLI Command Reference
September 2014 Page 697
HP Moonshot Switch Module CLI Command Reference
Table 40: 802.3ad Log Messages
Component Message Cause
802.3ad dot3adReceiveMachine: received default
event %x
Received a LAG PDU and the RX state
machine is ignoring this LAGPDU.
802.3ad dot3adNimEventCompletionCallback,
dot3adNimEventCreateCompletionCallback:
DOT3AD: notification failed for event(%d),
intf(%d), reason(%d)
The event sent to NIM was not completed
successfully.
Table 41: FDB Log Message
Component Message Cause
FDB fdbSetAddressAgingTimeOut: Failure setting
fid %d address aging timeout to %d
Unable to set the age time in the hardware.
Table 42: Double VLAN Tag Log Message
Component Message Cause
Double Vlan Tag dvlantagIntfIsConfigurable: Error accessing
dvlantag config data for interface %d
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no pre-
configuration.
Table 43: IPv6 Provisioning Log Message
Component Message Cause
IPV6 Provisioning ipv6ProvIntfIsConfigurable: Error accessing
IPv6 Provisioning config data for interface %d
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no pre-
configuration.
Table 44: MFDB Log Message
Component Message Cause
MFDB mfdbTreeEntryUpdate: entry does not exist Trying to update a non existing entry.