Command Reference Guide

Switching
CLI Command Reference
September 2014 Page 698
HP Moonshot Switch Module CLI Command Reference
Table 45: 802.1Q Log Messages
Component Message Cause
802.1Q dot1qIssueCmd: Unable to send message %d to
dot1qMsgQueue for vlan %d - %d msgs in queue
dot1qMsgQueue is full.
802.1Q dot1qVlanCreateProcess: Attempt to create a
vlan with an invalid vlan id %d ;
VLAN %d not in range,
This accommodates for reserved vlan ids. i.e.
4094 - x.
802.1Q dot1qMapIntfIsConfigurable: Error accessing
DOT1Q config data for interface %d in
dot1qMapIntfIsConfigurable.
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no pre-
configuration.
802.1Q dot1qVlanDeleteProcess: Deleting the default
VLAN
Typically encountered during clear Vlan and
clear config.
802.1Q dot1qVlanMemberSetModify,
dot1qVlanTaggedMemberSetModify: Dynamic
entry %d can only be modified after it is
converted to static
If this vlan is a learnt via GVRP then we
cannot modify its member set via
management.
802.1Q dtl failure when adding ports to vlan id %d -
portMask = %s
Failed to add the ports to VLAN entry in
hardware.
802.1Q dtl failure when deleting ports from vlan id %d -
portMask = %s
Failed to delete the ports for a VLAN entry
from the hardware.
802.1Q dtl failure when adding ports to tagged list for
vlan id %d - portMask = %s
Failed to add the port to the tagged list in
hardware.
802.1Q dtl failure when deleting ports from tagged list
for vlan id %d - portMask = %s"
Failed to delete the port to the tagged list
from the hardware.
802.1Q dot1qTask: unsuccessful return code on receive
from dot1qMsgQueue: %08x"
Failed to receive the dot1q message from
dot1q message queue.
802.1Q Unable to apply VLAN creation request for VLAN
ID %d, Database reached MAX VLAN count!
Failed to create VLAN ID, VLAN Database
reached maximum values.
802.1Q Attempt to create a vlan (%d) that already exists Creation of the existing Dynamic VLAN ID
from the CLI.
802.1Q DTL call to create VLAN %d failed with rc %d" Failed to create VLAN ID in hardware.
802.1Q Problem unrolling data for VLAN %d Failed to delete VLAN from the VLAN
database after failure of VLAN hardware
creation.
802.1Q VLAN %d does not exist Failed to delete VLAN entry.
802.1Q VLAN %d requestor type %d does not exist Failed to delete dynamic VLAN ID if the given
requestor is not valid.
802.1Q Can not delete the VLAN, Some unknown
component has taken the ownership!
Failed to delete, as some unknown
component has taken the ownership.
802.1Q Not valid permission to delete the VLAN %d
requestor %d
Failed to delete the VLAN ID as the given
requestor and VLAN entry status are not
same.
802.1Q VLAN Delete Call failed in driver for vlan %d Failed to delete VLAN ID from the hardware.