Command Reference Guide

QoS
CLI Command Reference
September 2014 Page 701
HP Moonshot Switch Module CLI Command Reference
QoS
Table 49: ACL Log Messages
Component Message Cause
ACL Total number of ACL rules (x) exceeds max (y)
on intf i.
The combination of all ACLs applied to an
interface has resulted in requiring more rules
than the platform supports.
ACL ACL name, rule x: This rule is not being
logged
The ACL configuration has resulted in a
requirement for more logging rules than the
platform supports. The specified rule is
functioning normally except for the logging
action.
ACL aclLogTask: error logging ACL rule trap for
correlator number
The system was unable to send an SNMP trap
for this ACL rule which contains a logging
attribute.
ACL IP ACL number: Forced truncation of one or
more rules during config migration
While processing the saved configuration,
the system encountered an ACL with more
rules than is supported by the current
version. This may happen when code is
updated to a version supporting fewer rules
per ACL than the previous version.
Table 50: CoS Log Message
Component Message Cause
COS cosCnfgrInitPhase3Process: Unable to apply
saved config -- using factory defaults
The COS component was unable to apply the
saved configuration and has initialized to the
factory default settings.
Table 51: DiffServ Log Messages
Component Message Cause
DiffServ diffserv.c 165: diffServRestore Failed to reset
DiffServ. Recommend resetting device
While attempting to clear the running
configuration an error was encountered in
removing the current settings. This may lead
to an inconsistent state in the system and
resetting is advised.
DiffServ Policy invalid for service intf: “policy name,
interface x, direction y
The DiffServ policy definition is not
compatible with the capabilities of the
interface specified. Check the platform
release notes for information on
configuration limitations.