Command Reference Guide

O/S Support
CLI Command Reference
September 2014 Page 706
HP Moonshot Switch Module CLI Command Reference
O/S Support
Switching Silicon USL: failed to sync L3 Route table on unit = x Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued.
Switching Silicon USL: failed to sync initiator table on unit = x Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued.
Switching Silicon USL: failed to sync terminator table on
unit = x
Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued.
Switching Silicon USL: failed to sync ip-multicast table on
unit = x
Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued.
Table 60: Linux BSP Log Message
Component Message Cause
Linux BSP rc = 10 Second message logged at bootup, right
after Starting code…. Always logged.
Table 61: OSAPI Linux Log Messages
Component Message Cause
OSAPI Linux osapiNetLinkNeighDump: could not open
socket! - or –
ipstkNdpFlush: could not open socket! – or –
osapiNetlinkDumpOpen: unable to bind
socket! errno = XX
Couldn’t open a netlink socket. Make sure
“ARP Daemon support” (CONFIG_ARPD) is
enabled in the Linux kernel, if the reference
kernel binary is not being used.
OSAPI Linux ipstkNdpFlush: sending delete failed Failed when telling the kernel to delete a
neighbor table entry (the message is
incorrect).
OSAPI Linux unable to open /proc/net/ipv6/conf/default/
hop_limit
IPv6 MIB objects read, but /proc filesystem is
not mounted, or running kernel does not
have IPV6 support.
OSAPI Linux osapimRouteEntryAdd, errno XX adding 0xYY
to ZZ – or –
osapimRouteEntryDelete, errno XX deleting
0xYY from ZZ
Error adding or deleting an IPv4 route (listed
in hex as YY), on the interface with Linux
name ZZ Error code can be looked up in
errno.h.
OSAPI Linux l3intfAddRoute: Failed to Add Route – or –
l3intfDeleteRoute: Failed to Delete Route
Error adding or deleting a default gateway in
the kernel’s routing table (the function is
really osapiRawMRouteAdd()/Delete()).
Table 59: Switching Silicon Error Messages (Cont.)
Component Message Cause