Command Reference Guide

User Account Commands
CLI Command Reference
September 2014 Page 90
HP Moonshot Switch Module CLI Command Reference
passwords strength maximum repeated-characters
Use this command to set the maximum number of repeated characters to be used in password strength. The
valid range is 0-15. The default is 0. Minimum of 0 means no restriction on that set of characters.
passwords strength minimum uppercase-letters
Use this command to enforce a minimum number of uppercase letters that a password should contain. The
valid range is 0-16. The default is 2. Minimum of 0 means no restriction on that set of characters.
no passwords strength minimum uppercase-letters
Use this command to reset the minimum uppercase letters required in a password to the default value.
passwords strength minimum lowercase-letters
Use this command to enforce a minimum number of lowercase letters that a password should contain. The
valid range is 0-16. The default is 2. Minimum of 0 means no restriction on that set of characters.
no passwords strength minimum lowercase-letters
Use this command to reset the minimum lower letters required in a password to the default value.
Default 0
Format
passwords strength maximum consecutive-characters 0-15
Mode Global Config
Default 2
Format
passwords strength minimum uppercase-letters
Mode Global Config
Format
no passwords minimum uppercase-letter
Mode Global Config
Default 2
Format
passwords strength minimum lowercase-letters
Mode Global Config
Format
no passwords minimum lowercase-letter
Mode Global Config