Command Reference Guide

User Account Commands
CLI Command Reference
September 2014 Page 91
HP Moonshot Switch Module CLI Command Reference
passwords strength minimum numeric-characters
Use this command to enforce a minimum number of numeric characters that a password should contain. The
valid range is 0-16. The default is 2. Minimum of 0 means no restriction on that set of characters.
no passwords strength minimum numeric-characters
Use this command to reset the minimum numeric characters required in a password to the default value.
passwords strength minimum special-characters
Use this command to enforce a minimum number of special characters that a password should contain. The
valid range is 0-16. The default is 2. Minimum of 0 means no restriction on that set of characters.
no passwords strength minimum special-characters
Use this command to reset the minimum special characters required in a password to the default value.
passwords strength minimum character-classes
Use this command to enforce a minimum number of characters classes that a password should contain.
Character classes are uppercase letters, lowercase letters, numeric characters and special characters. The valid
range is 0-4. The default is 4.
no passwords strength minimum character-classes
Use this command to reset the minimum number of character classes required in a password to the default
value.
Default 2
Format
passwords strength minimum numeric-characters
Mode Global Config
Format
no passwords minimum numeric-characters
Mode Global Config
Default 2
Format
passwords strength minimum special-characters
Mode Global Config
Format
no passwords minimum special-characters
Mode Global Config
Default 4
Format
passwords strength minimum character-classes
Mode Global Config
Format
no passwords minimum character-classes
Mode Global Config