Command Reference Guide

101
• qos wred table
queue ecn
Use queue ecn to enable ECN for a queue.
Use undo queue ecn to restore the default.
Syntax
queue queue-id ecn
undo queue queue-id ecn
Default
ECN is not enabled on any queue.
Views
WRED table view
Predefined user roles
network-admin
Parameters
queue-id: Specifies a queue by its ID in the range of 0 to 7.
Usage guidelines
When both the receiver and sender support ECN, the device can notify the peer end of the congestion
status by identifying and setting the ECN flag. ECN avoids deteriorating congestion.
Examples
# In WRED table queue-table1, enable ECN for queue 1.
<Sysname> system-view
[Sysname] qos wred queue table queue-table1
[Sysname-wred-table-queue-table1] queue 1 ecn
Related commands
• display qos wred table
• qos wred table
queue weighting-constant
Use queue weighting-constant to specify an exponent for average queue length calculation for a queue.
Use undo queue weighting-constant to restore the default.
Syntax
queue queue-id weighting-constant exponent
undo queue queue-id weighting-constant
Default
The exponent for average queue length calculation is 9.