Command Reference Guide

Examples

# Display the QoS policy applied to the incoming traffic of FortyGigE 1/1/1.

<Sysname> display qos policy interface FortyGigE 1/1/1 inbound

Interface: FortyGigE1/1/1

Direction: Inbound

Policy: 1

Classifier: 1

Operator: AND

Rule(s) : If-match acl 2000

Behavior: 1

Marking:

Remark dscp 3

Committed Access Rate:

CIR 128 (kbps), CBS 8192 (Bytes), EBS 512 (Bytes)

Green action: pass

Yellow action: pass

Red action: discard

Green packets: 0 (Packets)

Red packets: 0 (Packets)

Classifier: 2

Operator: AND

Rule(s) : If-match protocol ipv6

Behavior: 2

Accounting Enable:

0 (Packets)

Filter Enable: Permit

Marking:

Remark dot1p 1

Table 24 Command output

Field Descri

tion

Direction Direction in which the QoS policy is applied to the interface.

Green packets Traffic statistics for green packets.

Red packets Traffic statistics for red packets.

For the description of other fields, see Table 16 and Table 19.

display qos vlan-policy

Use display qos vlan-policy to display QoS policies applied to VLANs.

Syntax

display qos vlan-policy { name policy-name | vlan [ vlan-id ] } [ slot slot-number ] [ inbound | outbound ]