Command Reference Guide

85
This command is available only on a WRR-enabled interface. Queues in the SP group are scheduled with
SP. The SP group has higher scheduling priority than the WRR group. Queues in a WRR group are
scheduled according to user-configured weights, and WRR groups are scheduled at a 1:1 ratio.
Examples
# Enable packet-based WRR queuing on FortyGigE 1/1/1, and assign queue 0 to the SP group.
<Sysname> system-view
[Sysname] interface FortyGigE 1/1/1
[Sysname-FortyGigE1/1/1] qos wrr weight
[Sysname-FortyGigE1/1/1] qos wrr 0 group sp
Related commands
• display qos queue wrr interface
• qos wrr
WFQ commands
display qos queue wfq interface
Use display qos queue wfq interface to display the WFQ configuration on an interface.
Syntax
display qos queue wfq interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number. If you do not specify an
interface, this command displays the WFQ configuration of all the interfaces.
Examples
# Display the WFQ configuration of FortyGigE 1/1/1.
<Sysname> display qos queue wfq interface FortyGigE 1/1/1
Interface: FortyGigE1/1/1
Output queue: Hardware Weighted Fair Queuing
Queue ID Group Byte-count Min-Bandwidth
----------------------------------------------------------------
be 1 1 64
af1 1 1 64
af2 1 1 64
af3 1 1 64
af4 1 1 64
ef 1 1 64
cs6 1 1 64