Legato Networker ClientPak and Storage Node User's Guide

Recovering a Directory

Once you have started the NSRRECOV program, you can recover an entire directory.

This section assumes that you have started the NSRRECOV program and have

changed to the save set where the recovery directory resides.

To recover an entire directory, follow these steps:

1. Mark the directory that you want to recover by entering the NetWorker add

command and the name of the directory:

recover> add

reports

The following message is displayed:

6 file(s) marked for recovery

2. (Optional) Verify the marked files in the recovery list as follows:

recover> list

/projects/project1/reports/ @ Fri Nov 21 19:00:00 1997

/projects/project1/reports/rep1 @ Fri Nov 21 19:00:00 1997

/projects/project1/reports/rep2 @ Fri Nov 21 19:00:00 1997

/projects/project1/reports/rep3 @ Fri Nov 21 19:00:006 1997

/projects/project1/reports/rep4 @ Fri Nov 21 19:00:00 1997

/projects/project1/reports/rep5 @ Fri Nov 21 19:00:00 1997

6 file(s) marked for recovery

3. Start the recovery process by entering the recover command at the NetWorker

recover prompt:

recover> recover

NetWorker displays the following message:

Recovering 6 files into their original locations

FILES RESTORED : 5

Volumes needed (all on-line):

jupiter.012 at /source/rmt/data

Requesting 6 file(s), this may take a while...

>> TURBO-STORE/RESTORE VERSION C.55.29 B5152AA

RESTORE ; ;SHOW;NW3K;CREATE

WED, DEC 17, 1997, 4:58 PM

’CREATE’ OPTION DEFAULTING TO

’CREATE=ACCOUNT,GROUP,CREATOR,PATH’

BASED ON YOUR CAPABILITIES (S/R 502)

WARNING: YOUR DEFAULT FILESET BECOMES ’@.@.@’ SINCE YOU HAVE OP

OR SM CAPABILITY (S/R 1911)