System Startup, Configuration, and Shutdown Reference Manual (32650-90892)

Appendix G 235
UPS and UPS Monitor/iX Software
Configuring a UPS Device
Architected interface record 130 0N
Password changes 134 ON
System logging configuration 135 ON
Restore logging 136 ON
Printer access failure 137 ON
ACD changes 138 ON
Stream initiation 139 ON
User logging 140 ON
Process creation 141 ON
Chgroup record 143 ON
File open record 144 ON
Maintenance request log 146 OFF
UPS Monitor Event Logging 148 OFF
Diagnostic Information 150 ON
High Priority Machine Check 151 ON
Low Priority Machine Check 152 ON
Directory Open/Close Logging 155 OFF
CM File Close 160 OFF
Chdir 161 OFF
Process Adoption 162 OFF
File Owner Change 163 OFF
log>
To Review UPS Activity Recorded in the System Log File
UPS Monitor/iX status and alarm messages are recorded in the system log files as event
number 148. You can use the LOGTOOL utility to review entries in the system log file
about the performance and condition of UPS devices on your system. To do so, follow these
steps:
1. List the names of the log files currently on your system. At the MPE prompt, enter:
:LISTFILE LOG@.PUB.SYS
Note the number of the last log file in the list (other than LOGDCC). You will use it in step
5.
2. Start the system diagnostic utility. At the MPE prompt, enter:
:SYSDIAG
3. Run the LOGTOOL utility. Enter:
DUI >RUN LOGTOOL
4. To review the current logfile, use the SWITCHLOG command to close it and open a new
one.
DUI >SWITCHLOG
5. List the UPS-related messages (which are recorded as system log event number 148) in
the log file that you want to review. For example, if the last log file displayed with the
LISTFILE command was LOG00017, enter:
DUI >LIST LOG=17;TYPE=148
Or, if the last log file was LOG00017 and you then issued the SWITCHLOG command, to