Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

166 AppendixA
Error Messages
Validation Error Messages
Action: Remove the duplicate ldev number.
Path: NMMGRpath — PAD device name for LDEV #nnn is being used
at DTS.DTCPC.SELECT.DTCname.CARD345.PAD5. (DTSERR=49)
(DTSERR 49) Cause: The same logical device (ldev) number is used more than once.
Action: Remove the duplicate ldev number.
Path: NMMGRpath — The same LDEV #nnn is being used at
DTS.DTCPC.SELECT.DTCname.CARD012. (DTSERR=50)
(DTSERR 50) Cause: The logical device (ldev) number is used more than once in the
CARD012 configuration.
Action: Remove any duplicate references to the ldev number.
Path: NMMGRpath — The same LDEV #nnn is being used at
DTS.DTCPC.SELECT.DTCname.CARD345. (DTSERR=51)
(DTSERR 51) Cause: The logical device (ldev) number is used more than once in the
CARD345 configuration.
Action: Remove any duplicate references to the ldev number.
Path: NMMGRpath — The same node name is being used at linkname.
(DTSERR=52)
(DTSERR 52) Cause: The same node name is used more than once.
Action: Remove the duplicate reference to the node name.
Path: NMMGRpath — Blank NODENAME. (DTSERR=53)
(DTSERR 53) Cause: A host node name is not specified on the screen specified in the
path.
Action: Enter a host node name on the screen specified in the path.
Path: NMMGRpath — The profile for LDEV #nnn, profilename, is not
defined. (DTSERR=54)
(DTSERR 54) Cause: An incorrect profile name was used for the logical device (ldev).
Action: Verify the profile name for the logical device in the DTS
Profile Selection screen.
Path: NMMGRpath — Profile profilename specified for non-nailed PAD
terminals is of PRINTER or PADPRINT type. (DTSERR=57)
(DTSERR 57) Cause: A printer or PAD printer profile is specified where only a
terminal or pad terminal profile is allowed.
Action: Change the printer profile to be a terminal profile.
Path: NMMGRpath — The profile for LDEV #nnn, profilename, is of
PADTERM or PADPRINT type. (DTSERR=58)
(DTSERR 58) Cause: A PAD terminal or PAD printer profile is specified where only a
terminal or printer profile is allowed.