Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

174 AppendixA
Error Messages
DCC Error Messages
DCC ERROR P-L, link name specified for the DTS does not exist.
(DCCERR=13)
(DCCERR 13) Cause: The link name configured in NMMGR on the DTS
Configuration screen does not exist.
Action: Go to the DTS Configuration screen and enter the link name,
then restart DTS.
DCC ERROR P-L, link name specified for the DTS is not available (link
status SSSSSSSS). (DCCERR=14)
(DCCERR 14) Cause: A problem occurred with the link hardware; the LANIC might
be in the wrong slot or it might not be connected to the LAN.
Action: Check the hardware configuration and connections, then
restart DTS.
DCC ERROR P-L, too many links configured. (DCCERR=15)
(DCCERR 15) Cause: More that eight links are configured.
Action: Delete all unused links so that eight or less links are used,
then restart DTS.
DCC ERROR P-L, message received on wrong subque. (DCCERR=16)
(DCCERR 16) Cause: A problem exists with the interprocess communication.
Action: Contact your Hewlett-Packard support representative.
DCC ERROR P-L, unrecognized message received. (DCCERR=17)
(DCCERR 17) Cause: A problem exists with the interprocess communication.
Action: Contact your Hewlett-Packard support representative.
DCC ERROR P-L, internal DCC logic error. (DCCERR=18)
(DCCERR 18) Cause: A problem internal to the DCC exists.
Action: Contact your Hewlett-Packard support representative.
DCC ERROR P-L, Link error status SSSSSSSS. LLIO path:
NMMGRpath (DCCERR=19)
(DCCERR 19) Cause: A problem occurred while configuring the link manager.
Action: Contact your Hewlett-Packard support representative.
DCC ERROR P-L, Add LDEV to class failure (HLIO status SSSSSSSS,
ldev LLL). (DCCERR=20)
(DCCERR 20) Cause: A class contains more than 255 devices, or a conflict in class
names exists, or NMCONFIG.PUB.SYS was not cross-validated with files
created with SYSGEN.
Action: Run SYSGEN to verify the conflict.