Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

186 AppendixA
Error Messages
DTCCNTRL Error Messages
Action: Reenter the command with a valid RECONF specification.
Valid values are ALL, X25, CARD, PASS, and LOGCL.
Invalid specification for FORCED parameter. Must be y or n.
(CTLERR 22)
CTLERR 22 Cause: A DTCCNTRL command was entered using the FORCED option
but an invalid value was specified in the FORCED parameter.
Action: Reenter the command with a valid FORCED specification.
Valid values are Y for “yes” and N for “no”.
PAD download failed. (CTLERR 23)
CTLERR 23 Cause: An attempt was made to start PAD support. A problem
occurred with the DTC while the PAD support values were being
downloaded.
Action: Check the DTC. Correct any problems then redownload.
Reenter the command to start PAD support.
X25 could not be stopped. (CTLERR 24)
CTLERR 24 Cause: The DTC failed while X.25 support was being deactivated.
Action: Correct any problems with the DTC or its system connection
then reenter the command to stop X.25 support.
PAD could not be stopped. (CTLERR 25)
CTLERR 25 Cause: The DTC failed while PAD support was being deactivated.
Action: Correct any problems with the DTC or its system connection
then reenter the command to stop PAD support.
Start PAD first. (CTLERR 26)
CTLERR 26 Cause: An attempt was made to download card-specific PAD
configuration values but PAD support is not active.
Action: Start PAD support using the STARTPAD function of DTCCNTRL
then retry the operation.
Start X25 and PAD first. (CTLERR 27)
CTLERR 27 Cause: An attempt was made to download card-specific configuration
values but X.25 and PAD support were not active.
Action: Start X.25 and PAD support using the STARTBOTH function of
DTCCNTRL then retry the operation.
System error : failed to create a port for DTCPROG, info = !,
subsys = !. (CTLERR 100)
CTLERR 100 Cause: Internal error.
Action: Contact your Hewlett-Packard support representative.