Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

48 Chapter3
Configuring DTCs Step-by-Step
Modify the Network Management Configuration File
Modify the Network Management
Configuration File
The network management configuration file (NMCONFIG.PUB.SYS)
contains information that is referenced during system boot-up. A
step-by-step procedure for creating or updating the host’s network
management configuration file follows.
NOTE Before modifying the NMCONFIG.PUB.SYS file, make a backup copy of
it. If the modifications made to the configuration file are successful,
purge the backup copy.
Step 1: Begin the Configuration Process
Run the NMMGR program. Node manager (NM) or network
administrator (NA) capabilities are required to run this program. To
run NMMGR, enter the following command at the MPE prompt and
then press the
[Return] key.
NMMGR.PUB.SYS
NOTE You must be logged on to the SYS account to modify the configuration
file.
Step 2: Open the Network Management
Configuration File
The Open Configuration/Directory File screen is displayed (Figure 3-1).
This screen lets you specify the configuration and backup file names.