Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

Chapter 3 49
Configuring DTCs Step-by-Step
Modify the Network Management Configuration File
Figure 3-1 Open Configuration/Directory File Screen
Follow the steps listed here to enter data for this screen. Refer to
“Fields” subsection on the next page for detailed information about each
field on the screen.
1. NMCONFIG.PUB.SYS is the name required by the software. Verify
that this name is displayed in the Configuration file name
field.
2. Verify that the name of the correct backup configuration file is in the
Configuration file name field. The default is
NMCBACK.PUB.SYS.
3. Press the
[Open Config] function key.
4. If the configuration file you are opening does not exist, the following
message will appear on the message line at the top of the screen:
Config file does not exist; press Open Config again to
create it.
Press the
[Open Config] key again to confirm the creation of the file you
specified.
Fields Configuration
file name The only valid configuration file name the system
recognizes for use by the network subsystem is
NMCONFIG.PUB.SYS .