Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

Chapter 3 53
Configuring DTCs Step-by-Step
Modify the Network Management Configuration File
response to this question. (If you are not configuring
X.25 connections, see Configuring Systems for
Terminals, Printers, and Other Serial Devices manual
for the correct configuration procedures.)
Step 4: Configure the Link
The Host Configuration screen is displayed when you press the [DTS]
function key at the Main screen (Figure 3-3).
This screen is used to configure the Datacommunications and Terminal
Subsystem (DTS) on the HP 3000. DTS defines the interaction between
the system and any asynchronous devices, such as terminals and
printers.
Figure 3-3 Host Configuration Screen (Host-Based)
1. “Local HP 3000 node name” is a display-only field. Verify that it
is correct.
2. The “Link name” field displays DTSLINK. This is used by the
HP 3000 DTS subsystem. Use this default.
3. In the “Physical path of LANIC” field, type the slot number for
the LANIC card in the host. See the default list for commonly used
slot numbers.