Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

Chapter 3 55
Configuring DTCs Step-by-Step
Modify the Network Management Configuration File
Local HP 3000
node name For display only. The local node name is configured on
the Main screen.
Link name The link name that will be used when device
connections, including PAD device connections, are
established. It must start with a letter and can be up to
eight alphanumeric characters. (Note that this link
name is different from the X.25 link name that you will
configure on the X.25 Configuration screen during NS
configuration.) The default is DTSLINK
Physical path of
LANIC This is the location of the DTS LANIC in the system’s
backplane.
The default physical path (slot numbers) for HP 3000
computers are listed below. These defaults optimize
performance and use of the computer’s cabinet space.
Before moving the LANIC into another slot, consult an
HP representative.
Number of
non-nailed PAD
terminals The number of non-nailed PAD terminals that will be
allowed to establish connections with this system over
an X.25 network.
Other than entering the non-nailed PAD terminal
profile name, no additional configuration is needed for
non-nailed connections.
Starting ldev
number The ldev number where the pool of non-nailed PAD
ldevs will be configured.
HP 3000 Systems Slot Number
920, 922, 935, 932, 935, or 949 with HPIB 4.3
920, 925, 935, or 949 with ALINK 4.2
9X7 56
9X8 56/56
930 8.4
950, 955, 960, 980 2/4.2
990/992, 991/995 0/40