Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

Chapter 3 57
Configuring DTCs Step-by-Step
Modify the Network Management Configuration File
Step 6: Specify DTC Configuration
The DTC Configuration screen is displayed after you select the DTC
type at the DTC Configuration Selection screen. Figure 3-5 shows the
DTC Configuration screen for a DTC 72MX. (DTC Configuration
screens for DTC 16iX, DTC 16MX/RX, DTC 16, and DTC 48 vary
slightly).
Figure 3-5 DTC Configuration Screen
1. Enter the DTC’s name in the “DTC name” field.
The DTC name can be up to eight alphanumeric characters,
beginning with a letter. The DTC name must be unique on the
system. It is acceptable (and common) to use the nodename part of
the “DTC node name” as the “DTC name”.
2. Enter the DTC’s LAN address in the “DTC LAN station
address” field.
The LAN address can be found on a label inside the front cover or on
the back panel of the actual DTC box.
For DTC 16RX access to an HP 3000 in an MPE/iX host-based
management environment, you must use the value
00-00-00-00-00-00 as the DTC 16RX LAN address.
3. Type in the DTC’s node name in the “DTC node name” field.