Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

Chapter 3 65
Configuring DTCs Step-by-Step
Modify the Network Management Configuration File
Figure 3-7 DTC X.25 Card Configuration Screen
1. Choose the screen that you want to move to. To create a new card
configuration, go to the screen that lets you configure level 1 and 2
parameters first. (If you are modifying an existing card
configuration, you may choose to move to one of the other choices
listed on the screen.)
2. Press the function key that corresponds to the screen that you want
to move to.
Fields This screen is used to select and move to the lower level DTC/X.25
Card Configuration screens. The function keys available for selection
and the corresponding lower level screens are shown below:
Go to
Level 1&2 Takes you& to the DTC X.25 Card Configuration —
Level 1 and 2 screen. Use this screen to configure
level 1 and 2 network parameters. Most of the
information you enter on this screen will be on the
subscription form for the packet switched network
you are connecting to. You must enter level 1 and 2
parameters for all DTC/X.25 Network Access cards
whether they support X.25 system-to-system
connections, PAD connections, or both.