Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

Chapter 3 73
Configuring DTCs Step-by-Step
Modify the Network Management Configuration File
Flow control
negotiation Specifies whether or not flow control negotiation is
enabled. When flow control negotiation is enabled, both
packet size and window size are negotiable. Enter Y if
your subscription allows flow control negotiation and
you wish to enable it. Otherwise enter N.
Use of D-bit Specifies whether or not delivery confirmation is
enabled. Enter Y if your subscription allows delivery
confirmation and you wish to enable it. Otherwise
enter N.
Throughput class
negotiation Specifies whether or not throughput class negotiation is
enabled. Enter Y if your subscription allows throughput
class negotiation and you wish to enable it. Otherwise
enter N.
Extended packet
sequence
numbering Specifies whether or not extended packet sequence
numbering is enabled. Enter Y if your subscription
allows extended packet sequence numbering and you
wish to enable it. Otherwise enter N.
Step 11: Configure X.25 System-to-System
Information
NMMGR displays the DTC X.25 Card Configuration — Sys-to-Sys
LUGs screen (Figure 3-10) if you press the
[Go To SysLUG] key at the
DTC X.25 Card Configuration screen or the DTC X.25 Card
Configuration — Level 3 & Miscellaneous screen. On this screen, you
specify information for X.25 system-to-system connections. You can also
reach this screen by typing the following path at the Command line and
pressing the
[ENTER] key:
@DTS.DTC.SELECT.dtcname.X25CARDn.SYSLUG