Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

Chapter 3 77
Configuring DTCs Step-by-Step
Modify the Network Management Configuration File
Address The X.25 addresses of the remote systems in your
X.25 network
Sec. The security level associated with each remote X.25
address. To accept only incoming calls for call setup,
enter IN in the security field beside the address. To
allow only outgoing calls for call setup, enter OU. To
allow both incoming and outgoing calls for call
setup, enter IO.
Step 12: Configure Nailed PAD Connections
NMMGR displays the DTC X.25 Card Configuration – Nailed PAD
Connections screen (Figure 3-11) if you press the
[Go To PAD] key from
the DTC X.25 Card Configuration screen or the DTC X.25 Card
Configuration — Sys-to-Sys LUGs screen. On this screen, logical device
(ldev) numbers, profile names, device names, and remote X.25
addresses are permanently associated with individual PAD connections
allowed through the card. Configure the connections as required. You
can also reach this screen by typing the following path at the Command
line and pressing the
[ENTER] key:
@DTS.DTC.SELECT.dtcname.CARD012.PADn
or
@DTS.DTC.SELECT.dtcname.CARD345.PADn
Figure 3-11 DTC X.25 Card Configuration — Nailed PAD Connections