Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

Chapter 3 85

Conﬁguring DTCs Step-by-Step

Modify the Network Management Conﬁguration File

NOTE

For host-based X.25 conﬁguration tasks and associated actions for

changes to take effect, refer to Conﬁguring and Managing Host-Based

X.25 Links for more information.

Performing a DTC Reset

First, logoff any sessions. To reset the DTC, turn off the power and then

turn on the power again for the DTC.

You may also use TermDSM, an online diagnostic program for

host-managed DTCs, to reset the DTC. Refer to Troubleshooting

Terminal, Printer, and Serial Device Connections for more information.

Performing a DTS Shutdown/Restart

To perform a DTS shutdown and restart, use the DTCCNTRL

command. Refer to Chapter 7, “Managing Networks with DTCCNTRL,”

for the command syntax of this command. Refer to the Dynamic

Conﬁguration chapter of the Conﬁguring Systems for Terminals,

Printers, and Other Serial Devices manual for additional information on

performing a DTS shutdown and restart.