HP System Dictionary/XL SDMAIN Reference Manual (32256-90001)

A-172
ACTION Delete can consist of a continuous string of one or more D' s or two single D' s, with
blanks between. The only other command allowed on the same line as a Delete is an
Insert (I). It (I) is allowed after either of the two D strings.
1432 MESSAGE The entire command has been deleted (SDWARN 1432)
CAUSE The entire command in the REDO buffer has been deleted.
ACTION Since the entire command was deleted, the REDO system returns to the command
mode. Edit the original command or issue a new command.
1433 MESSAGE Unexpected characters after REDO command (SDERR 1433)
CAUSE There are characters on the line after the REDO system command. Except for the D/I
combination, only a single edit command can be entered on a line.
ACTION Reissue the edit command with only a single command on the line.
1434 MESSAGE + and - NOT allowed in a number (SDERR 1434)
CAUSE The numbers used to move within REDO buffer cannot involve a + or -.
ACTION Remove the + or - from the number specifying how far to move and simply use the
appropriate command to specify direction (+ to move forward and - to move backward).
1435 MESSAGE The quoted string after REDO must contain at least one char (SDERR 1435)
CAUSE The string specified after the REDO command contains no characters (or only blanks).
A qualifying value must contain at least one non-blank character.
ACTION Reenter the REDO command specifying a qualifying string to be used to determine the
appropriate command to select from the redo history stack.
1436 MESSAGE No match found for the requested string in the redo stack (SDERR 1436)
CAUSE No match was found for the specified string in the redo history stack.
ACTION Use the SHOWREDO command to obtain a list of the commands currently in the redo
history stack. If the desired command is present, select it by number (either absolute
or relative) or provide a qualifying string that matches the start of the command.
1437 MESSAGE No command is currently stored in the referenced location (SDERR 1437)
CAUSE No command is stored in the redo stack at the location referred to by the absolute or
relative number offset specified.
ACTION Use the SHOWREDO command to obtain a list of the commands currently in the redo
history stack. Specify an absolute or relative command number that will refer to one of
the commands listed by the command or issue a command that performs the desired
action.
Renumber/Resequence Messages (1450-1474)
1450 MESSAGE Cannot resequence the relationship due to a collision (SDERR 1450)
CAUSE The relationship cannot be resequenced as there is no relationship-position number
available at the destination location (either the relationship must go before a
relationship with relationship-position of 1, after a relationship with relationship-
position of the maximum value, or between two relationships numbered consecutively).