NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 12 123
NETXPORTERR Error Messages
ACTION: Review the referenced NMERR elsewhere in this manual.
Confirm that there have been no validation errors with this
configuration file. If the error still occurs, see Appendix A , “Submitting
a CR,” of this manual.
4101 MESSAGE: TRANSPORT NOT YET DOWN.
CAUSE: Detected upon issuing a NETCONTROL START command. The
prior NETCONTROL STOP command failed to completely terminate the
Network Transport.
ACTION: Perform the following steps:
1. Wait a few minutes, then retry the NETCONTROL START command. If
the problem persists, abort any remaining network users.
2. Submit an CR any time this problem occurs. See Appendix A ,
“Submitting a CR.”
4200 MESSAGE: CONFIGURATION FILE NOT OPENED.
CAUSE: Opening the configuration file failed.
ACTION: Confirm that the configuration file NMCONFIG.PUB.SYS exists
and is valid. Retry the NETCONTROL command.
4201 MESSAGE: INTERNAL BUFFER ERROR.
CAUSE: Creating a network transport buffer area failed.
ACTION: See Appendix A , “Submitting a CR.”
4202 MESSAGE: INTERNAL CONFIGURATION FILE ERROR (NMERR= error
number).
CAUSE: Accessing the configuration file returned the specified error.
ACTION: Review the description of the NMERR referenced elsewhere
in this manual. Confirm that there are no validation errors with the
configuration file. If the error still occurs, restore a backup copy of the
configuration file NMCONFIG.PUB.SYS.
4203 MESSAGE: INTERNAL ERROR ON START.
CAUSE: A serious internal error has been detected during the execution
of the NETCONTROL START command.
ACTION: SeeAppendix A , “Submitting a CR,” of this manual.
4204 MESSAGE: linkname DEVICE STARTUP FAILED.
CAUSE:
1. The configured device does not exist on the system.
2. The link connection is bad due to faulty hardware.
3. An internal error has occurred during device startup.