NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 14 139
VALERR and VALWARN Messages
ACTION: Use NMMGR to configure all classes under the path
LOGGING.SUB0040. Validate the network transport configuration again.
115 MESSAGE: LINK TYPE FOR SNA NI MUST BE SNA.
CAUSE: A link of type SNA must be used when configuring an NI for NS
over SNA.
ACTION: Use NMMGR to configure a link of type SNA. Validate
Transport again.
300 MESSAGE: FACILITY SET setname DOES NOT EXIST.
CAUSE: In the SVCPATH configuration an X.25 address key is mapped to
an undefined facility set.
ACTION: Modify the X.25 address key so that it is mapped to an existing
facility set. Or, create a new facility set with the name to which the X.25
address key is mapped.
313 MESSAGE: MUST DEFINE AT LEAST ONE X.25 ADDRESS KEY IN
SVCPATH OR PVCPATH.
CAUSE: At least one X.25 address key must be configured under either
the NETXPORT.NI.NIname.PROTOCOL.X25.SVCPATH or the
NETXPORT.NI.NIname.PROTOCOL.X25.PVCPATH path.
ACTION: Use NMMGR to configure an address key under either the
NETXPORT.NI.NIname.PROTOCOL.X25.SVCPATH or the
NETXPORT.NI.NIname.PROTOCOL.X25.PVCPATH path.
322 MESSAGE: MORE THAN 1024 X.25 ADDRESS KEYS CONFIGURED
(SVC + PVC).
CAUSE: More than the allowed number of address keys were defined.
The maximum number of combined SVC and PVC address keys allowed
is 1024.
ACTION: Use NMMGR to delete excess address key paths.
323 MESSAGE: X.25 ADDRESS KEY key IS DEFINED MORE THAN ONCE.
CAUSE: An X.25 address key was defined more than once under either
the NETXPORT.NI.NIname.PROTOCOL.X25.SVCPATH or the
NETXPORT.NI.NIname.PROTOCOL.X25.PVCPATH path.
ACTION: Make sure an X.25 address key is configured only once. Delete
all but one of any given X.25 address key.
324 MESSAGE: PVC NUMBER pvc IS DEFINED MORE THAN ONCE.
CAUSE: A PVC number is defined more than once under the
NETXPORT.NI.NIname.PROTOCOL.X25.PVCPATH path.
ACTION: Make sure all PVC numbers are unique in a given PVC
configuration path.