NS3000/iX Error Messages Reference Manual (36923-90043)

144 Chapter15
LAN, LAN/Console, Token Ring LAN Error Messages
7 MESSAGE: A call to IO_CONFIG_INT failed during driver initialization.
CAUSE: Unknown. Need more information.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
8 MESSAGE: A call to IO_DECONFIG_INT failed during driver
shutdown.
CAUSE: Unknown. Need more information.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
9 MESSAGE: A call to IO_FLUSH_INT failed during power fail recovery.
CAUSE: Unknown. Need more information.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
10 MESSAGE: Unable to obtain an I/O Services timer.
CAUSE: A call to obtain a timer resource returned an error. Too many
timers may be in use.
ACTION: If you suspect your system might be low on timer resources
because of heavy loading, try restarting the link later. If repeated
attempts fail, try warmstarting your system. If the problem persists, a
system dump will be required. Call your Hewlett-Packard
representative.
11 MESSAGE: Unable to release an I/O Services timer.
CAUSE: The driver tried to free a timer that was not recognized by the
system as valid. Memory data corruption may have occurred.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
12 MESSAGE: Unable to release an I/O Services message frame.
CAUSE: A call to the system message freeing routine returned an error.
The port may belong to a process that no longer exists or is not
operating with the required capabilities. Also, the message frame may
not have been recognized by the system as a valid message frame.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
13 MESSAGE: Unable to retrieve an I/O Services message frame.
CAUSE: A call to the system message retrieve routine returned an error.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.