NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 16 189
100VG-AnyLAN and HP-PB 100Base-T Error Messages
SDI Driver Specific Status Values
161 ($A1) MESSAGE: Card did not go ready after hard reset.
CAUSE: After performing a hard reset of the adapter card during
startup, the HP-PB interface chip did not report “ready” status, or
reported an error.
ACTION: Replace the adapter card. If the same problem persists even
after replacement with a known good card, contact Hewlett-Packard:
your software could be out of date, but a patch may be available. It is
unlikely this would be caused by a system HP-PB bus hardware
problem.
162 ($A2) MESSAGE: An expected PHY interrupt did not arrive.
CAUSE: During a link connect sequence, the driver requested a test
interrupt from the PHY chip on the adapter card, but received a
timeout. The driver cannot connect the link if PHY interrupts do not
work.
ACTION: Replace the adapter card. The link did not connect. If the
problem persists with a known good card, see Appendix A , “Submitting
a CR.”
163 ($A3) MESSAGE: Timeout while awaiting a link training transmit interrupt.
CAUSE: During a 100VG-AnyLAN link connect attempt, the driver
received a training frame from the 100VG-AnyLAN hub in response to
a previous send, but no interrupt arrived for the last frame it sent
within the 2 ms time allowed.
ACTION: This error is informational only. The driver will retry the
connect. If the problem happens every time, try replacing the cable
and/or adapter card.
164 ($A4) MESSAGE: Timeout while awaiting a link training receive.
CAUSE: After successfully sending a training frame to the
100VG-AnyLAN hub, no frames were received back from the hub
within the 50 ms time allowed. The hub should return one frame for
every frame sent.
ACTION: This error is informational only. The driver will retry the
connect. If the problem persists, try reducing the CPU load. The hub
sent a training idle signal, but it is not responding to frames sent to it
by the link driver. Make sure the link’s NMCONFIG configuration is
not forcing use of a MAC address already in use by some other link; in
this case the hub may not respond. Try replacing the cable and/or
adapter card. Check the hub port configuration.
165 ($A5) MESSAGE: Timeout while awaiting any link training interrupt.
CAUSE: During a 100VG-AnyLAN link connect attempt, the driver sent
a training frame to the 100VG-AnyLAN hub, but no interrupt arrived
within the 50 ms time allowed, for either the frame which was sent, or a
receive from the hub in response to it.