Manualshelf

NS3000/iX Error Messages Reference Manual (36923-90043)

ManualsBrandsHP ManualsSoftwareMPE/iX 7.5 Operating System
11121314151617181920
Chapter 1 19
CIERR Error Messages
terminates all network services, including the local Virtual Terminal
service.
ACTION: Issue either an NSCONTROL START or an NSCONTROL
START=VTL to start the local VT service, or wait until the service is
started. (Only users with NM capability can use the NSCONTROL
command.)
5038 MESSAGE: VIRTUAL TERMINAL SERVICE DETECTED AN ERROR.
CAUSE: An error was detected by the Virtual Terminal server process.
The error message for the VT error will precede the CI error message.
ACTION: Some of the VT errors are normal responses (e.g., REMOTE NOT
ACCEPTING CHANGE REQUESTS) and some are internal errors
(e.g., UNEXPECTED/BAD RESPONSE FROM VT). Look up the VT error
message for the appropriate action to take.
5039 MESSAGE: INTERNAL DS ERROR — COULD NOT SEND REMOTE
COMMAND.
CAUSE: A port message with the remote command could not be sent
from the CI to the Virtual Terminal server process.
ACTION: See “Submitting an CR” in Appendix A of this manual.
5040 MESSAGE: INVALID TRACE INFORMATION.
CAUSE: Information in a DSLINE TRACE option was incorrect. A DS
error will also be displayed.
ACTION: Correct the TRACE option and reissue the command.
5041 MESSAGE: COULD NOT USE ENVIRONMENT.
CAUSE: This CI error is returned for a number of errors detected when
the environment in a DSLINE or REMOTE command cannot be used. One
or more DS errors will accompany this CI error to more fully describe
the error or errors.
ACTION: Correct the command, based on the DS errors, and reissue.
5042 MESSAGE: COULD NOT USE GENERIC ENVIRONMENT.
CAUSE: This CI error is returned for a number of errors detected when
a generic environment in a DSLINE command cannot be used. One or
more DS errors will accompany this CI error to more fully describe the
error or errors.
ACTION: Correct the command, based on the DS errors, and reissue.
5043 MESSAGE: ALL DSLINE OPTIONS BUT CLOSE ARE IGNORED.
CAUSE: Other options besides CLOSE were specified in a DSLINE
command.
ACTION: None (the selected environment is closed).