NS3000/iX Error Messages Reference Manual (36923-90043)

190 Chapter16
100VG-AnyLAN and HP-PB 100Base-T Error Messages
SDI Driver Specific Status Values
ACTION: This error is informational only. The driver will retry the
connect. If the problem happens every time, try replacing the cable
and/or adapter card.
170 ($AA) MESSAGE: Hub did not report link up within time allowed.
CAUSE: During a 100VG-AnyLAN link connect attempt, the driver
exchanged 24 training frames with the hub, but afterward the LINK
signal still did not appear within the 4 ms time allowed. The hub may
not have liked some or all of the frames, although it responded anyway.
If this error is logged, it is because the link did not connect within 25 to
30 seconds after it was instructed to do so.
ACTION: This error is informational only. The driver will retry the
connect. If the problem happens every time, try checking the hub port
configuration, or replacing the cable and/or adapter card.
171 ($AB) MESSAGE: Hub did not send link training idles within time allowed.
CAUSE: During a 100VG-AnyLAN link connect attempt, the driver
requested a training idle signal from the 100VG-AnyLAN hub, but no
idles arrived within the 400 ms time allowed.
ACTION: This error is informational only. The driver will retry the
connect. If the problem happens every time, first check that the cable is
good, is connected, and the hub is powered on. Try checking the hub
port configuration, or replacing the cable and/or adapter card.
172 ($AC) MESSAGE: Link training failed.
CAUSE: This is a generic error., reported if 100VG-AnyLAN link
training failed due to an unusual condition not covered by expected
error conditions. This might include LAN controller chip adapter
checks, timeouts, hardware failures, or power failures.
ACTION: This error is informational only. The driver will retry the
connect. If the problem happens every time, take a link trace while the
problem is occurring, then see Appendix A , “Submitting a CR.”
175 ($AF) MESSAGE: Timeout while awaiting link autonegotiation completion.
CAUSE: The link appears to be connected, but the driver thinks it is still
waiting for it to connect.
ACTION: This error should not occur. If it happens frequently, see
Appendix A , “Submitting a CR.”
183 ($B7) MESSAGE: Driver bug prevents link training. File CR.
CAUSE: During an attempt to establish the proper stack context within
which to begin 100VG-AnyLAN link training, the driver tried
repeatedly to run without the ISR underneath it, but failed to even
after 4 retries.
ACTION: Shut down the link and restart it. If the same problem still
occurs, see Appendix A , “Submitting a CR.”