NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 16 225
100VG-AnyLAN and HP-PB 100Base-T Error Messages
SDI Driver Specific Status Values
and current state: HP use only).
ACTION: The driver sent an error reply in response to the message.
Further action may not be required. If the problem occurs frequently,
try to determine what operator commands or actions trigger the error,
then see Appendix A , “Submitting a CR.”
3670 CLAS0001 MESSAGE: Late dump-done message received. Dump took too long.
CAUSE: The driver received a driver-dump completion message when it
was not working on a dump (“Cause” = 32-bit status saying there was a
bad message for the current state).
ACTION: This error is informational only. Probably the Network Dump
Process was delayed by other system processing, such that it exceeded
the time limit set by the driver. The resulting dump file may or may not
be incomplete. A more serious driver problem has already occurred,
after which the driver will now attempt to auto-reset and continue. If
you are trying to reproduce a specific problem but this error occurs
every time, reduce the CPU or disk activity load before the next
attempt.
If load is not the problem, see Appendix A , “Submitting a CR.”
3700 CLAS0001 MESSAGE: Internal error while initiating a dump. Dump failed.
CAUSE: The driver’s dump timer popped while performing a dump
operation (“Cause” = 32-bit status indicating a timeout has occurred).
Probably a heavy CPU or disk activity load caused the Network Dump
Process to take longer than the time allowed by the driver.
ACTION: This error is informational only. The resulting dump file may
or may not be incomplete. A more serious driver problem has already
occurred, and by the time this error is logged, the driver is already
attempting to auto-reset and continue. If you are trying to reproduce a
specific problem but this error occurs every time, reduce the CPU or
disk activity load before the next attempt.
3730 CLAS0001 MESSAGE: Link tracing is already enabled.
CAUSE: The driver received a request to turn link tracing on when it
was already on. Typically this condition is caught at the C.I. level,
however in this case trace may be under the control of a different
mechanism.
ACTION: No action is required; this error is informational only. An error
reply was sent in response to the request. Trace was not started by this
request this time, but it remains on.
3760 CLAS0001 MESSAGE: Bad message for current state.
CAUSE: The driver received a request to turn link tracing on either too
early or too late in the driver’s life cycle, or when the driver was already
broken (“Cause” = 16-bit encoded value, giving driver input event code
and current state: HP use only).