NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 16 273
100VG-AnyLAN and HP-PB 100Base-T Error Messages
SDI Driver Specific Status Values
• Bit 18 is 1 if the controller was attempting to read from adapter card
memory, 0 if it was writing.
• Bits 7–0 contain an error code, as follows:
— $01 = Bus master data parity error: replace hardware.
— $02 = Bus address parity error: replace hardware.
— $03 = Master abort: replace hardware first. If problem continues,
contact Hewlett-Packard.
— $04 = Target abort: replace hardware first. If problem continues,
contact Hewlett-Packard.
— $05 = List error: driver bug. Save NETDMP##.PUB.SYS file and see
Appendix A , “Submitting a CR.”
— $06 = Ack error: driver bug. Save NETDMP##.PUB.SYS file and see
Appendix A , “Submitting a CR.”
— $07 = Interrupt overflow error: driver bug. Save
NETDMP##.PUB.SYS file and see Appendix A , “Submitting a CR.”
9480 CLAS0001 MESSAGE: Adapter card produced an illegal interrupt.
CAUSE: The link driver has received an interrupt from the card during
normal operation, but the driver should have specifically disabled that
interrupt at startup (“Cause” = 16-bit value of the LAN Controller
chip’s host interrupt register: HP use only).
ACTION: The driver will attempt to perform a dump of all host context
data structures and adapter card memory, then reset itself and
continue. Save the resulting NETDMP##.PUB.SYS file for possible
analysis by Hewlett-Packard.
But first, replace the adapter card and see if this corrects the problem.
If not, see Appendix A , “Submitting a CR.”
9560 (None) MESSAGE:
(None)
CAUSE: 100VG-AnyLAN link training failed because the LAN
Controller chip unexpectedly reported a statistics overflow interrupt
during 100VG-AnyLAN link training. A hardware failure state was
then signaled.
This code would only appear in the formatted PHY chip trace from a
100VG-AnyLAN link connect failure. It would not appear in a log event.
Seeing this error implies you are already using link tracing to try to
debug a problem, or are analyzing driver context data directly.
ACTION: The driver cleared statistics already, so none should overflow
during link training unless there is a problem.
There could be a hardware or configuration problem with the
100VG-AnyLAN hub or switch. Check the wiring. Try plugging the card
into a different port on the 100VG-AnyLAN hub or switch. Replace the