NS3000/iX Error Messages Reference Manual (36923-90043)

314 Chapter17
PCI 100Base-T Error Messages
SDI Driver Specific Status Values
1120 CLAS0001 MESSAGE: Bad hardware ID or path.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator did not find a supported 100Base-T adapter
card at the hardware path specified in NMCONFIG.
ACTION: The module configurator cleaned up and returned an error to
the subsystem.
Verify the path in NMCONFIG is correct and complete, and matches
the path where a supported 100Base-T adapter card is installed in the
computer backplane. If necessary, reseat the board or contact your
Hewlett-Packard Representative for hardware assistance.
1130 CLAS0001 MESSAGE: Adapter card found does not match software
configuration.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator found a supported adapter card at the path
specified in NMCONFIG, but it was not the right type of card for the
link being started.
ACTION: Correct the network configuration or plug in the correct type of
adapter card, and retry the operation. The module configurator cleaned
up and returned an error to the subsystem.
1140 CLAS0001 MESSAGE: Cannot create a buffer pool.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator encountered an error while trying to create an
outbound buffer pool (“Cause” = 32-bit status from the call to
bmgr_create_pool).
ACTION: The system may be low on available memory. The module
configurator cleaned up and returned an error to the subsystem.
Try stopping some applications or sessions and retry the operation. If
the problem persists, stop all networking and restart it, or restart the
system.
The buffer size and pool size are not configurable. If the problem still
occurs, there could be a problem with the buffer manager. See Appendix
A , “Submitting a CR.”
1160 CLAS0001 MESSAGE: Cannot load driver plabel.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator encountered an error while trying to load the
code for the driver (“Cause” = 32-bit status from the call to
io_get_mgr_entry).
ACTION: Probably not all software required to operate this type of link
is installed. The software was incorrectly installed, or you may need to
purchase additional software or install newer patches. Reinstall the
link software or contact your Hewlett-Packard Representative for