NS3000/iX Error Messages Reference Manual (36923-90043)

36 Chapter2
DSERR Error Messages
CAUSE: The third (organization) part of a (fully qualified) environment
ID or node name is longer than the allowed 16 characters.
ACTION: Correct the name and reissue the command.
642 MESSAGE: ORGANIZATION IN name CONTAINS A
NON-ALPHANUMERIC CHARACTER.
CAUSE: The third (organization) part of a (fully qualified) environment
ID or node name contains a character that is not alphabetic or numeric
ACTION: Correct the name and reissue the command.
643 MESSAGE: TOO MANY HIERARCHY LEVEL IN name; EXPECTED
NAME.DOMAIN.ORG.
CAUSE: The fully qualified environment ID or node name has more than
three parts.
ACTION: Correct the name and reissue the command.
644 MESSAGE: TRANSPORT NOT INITIALIZED.
CAUSE: A DSLINE or REMOTE command has been issued and the Network
Transport has not been started by a NETCONTROL command.
ACTION: Wait until the transport is started, or issue a NETCONTROL to
start the transport. (Only users with NM capability can use the
NETCONTROL command.)
645 MESSAGE: UNKNOWN NODE nodename.
CAUSE: A DSLINE or REMOTE command was issued for a non-existent
node. Also, this error may be displayed when a valid NS node name is
used, but the NS transport has not been started.
ACTION: If the node name is invalid, correct the name and reissue the
command. If the node name is valid, wait for the transport to be started
or start the transport with the NETCONTROL command.
646 MESSAGE: name IS NOT A NODE NAME OR DS LOGICAL DEVICE.
CAUSE: A DSLINE command was issued using a DS logical device
instead of a node name.
ACTION: Use a node name or an environment name and issue the
command again.
647 MESSAGE: ALREADY LOGGED ON AS user.acct.
CAUSE: A DSLINE with a LOGON option has been issued for an
environment that has its remote session logged on
ACTION: Wait for the remote session to be logged off, or log off the
remote session (for example, by terminating any services using the
environment).