NS3000/iX Error Messages Reference Manual (36923-90043)

38 Chapter3
NS/NFTERR and NS/NFTWARN Messages
ACTION: Verify that the source-computer name is correct, that the
source computer is connected to the network, and that there are
sufficient resources to establish a connection. Also, refer to the
qualifying error string. Check the log file for PM errors.
6 MESSAGE: UNABLE TO CONNECT TO TARGET NODE.
CAUSE: A connection could not be established to the computer where
the target file resides. Either the target-computer name is incorrect, or
the target computer is not connected to the network, or there are
insufficient resources.
ACTION: Verify that the target-computer name is correct, that the
target computer is connected to the network, and that there are
sufficient resources to establish a connection. Also, refer to the
qualifying error string. Check the log file for PM errors.
7 MESSAGE: INSUFFICIENT RESOURCES ARE AVAILABLE ON
SOURCE NODE.
CAUSE: Insufficient resources at the source computer to carry out the
file transfer.
ACTION: Verify that there are sufficient resources on the source
computer and try again. Verify that DST tables are available. Check
that the configured maximum number of DST table entries is large
enough.
8 MESSAGE: INSUFFICIENT RESOURCES ARE AVAILABLE ON
TARGET NODE.
CAUSE: Insufficient resources at the target computer to carry out the
file transfer.
ACTION: Verify that there are sufficient resources on the target
computer and try again. Verify that DST tables are available. Check
that the configured maximum number of DST table entries is large
enough.
9 MESSAGE: SOURCE FILE WAS NOT FOUND.
CAUSE: Source file specified does not exist.
ACTION: Verify that the source file name is correct.
10 MESSAGE: TARGET FILE WAS NOT FOUND.
CAUSE: The target file does not exist and APPend was specified.
ACTION: Verify that the target file name is correct.
11 MESSAGE: TRANSFER STOPPED PER USER REQUEST.
CAUSE: Acknowledges the user’s Abort or Cancel request.
ACTION: None. This is an informational message only.