NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 18 403
PCI LAPBMUX Link Error Messages
SDI Driver Specific Status Values
Hewlett-Packard what actions the driver took. See Appendix A ,
“Submitting a CR.”
1080 CLAS0001 MESSAGE: Did not receive an expected port message.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator sent configuration data to the driver, then
encountered a timeout while awaiting the correct reply message
(“Cause” = 32-bit status from the call to extend_receive).
ACTION: There may be a system problem with message ports, or the
link driver may have sent the wrong reply message. The open did not
succeed. The module configurator cleaned up and returned an error to
the subsystem.
Perform a :LINKCONTROL @ command to see if an entry exists for the
linkname being started. If so, then run the VBPBA diagnostic tool and
attempt to force a driver dump. If that works, save the resulting
NETDMP##.PUB.SYS file for analysis by Hewlett-Packard. Otherwise,
halt the system and take a memory dump. The dump should tell
Hewlett-Packard what actions the driver took. See Appendix A ,
“Submitting a CR.”
1100 CLAS0001 MESSAGE:
(Varies)
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator sent configuration data to the driver, but the
driver returned an error in the reply message (“Cause” is not used
here).
ACTION: If this error occurs, there may be additional driver-specific
errors logged, giving more information about the problem. Attempt to
locate those errors and look them up also. The open did not succeed.
The module configurator cleaned up and returned an error to the
subsystem.
1120 CLAS0001 MESSAGE: Cannot freeze a memory area
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator was preparing to send configuration data to
the driver, but encountered an error while trying to freeze that data
into memory (“Cause” = 32-bit status from the call to freeze).
ACTION: The system may be low on available memory. Try closing any
unnecessary applications or sessions and retry the operation. The open
did not succeed. The module configurator cleaned up and returned an
error to the subsystem.
1140 CLAS0001 MESSAGE: Cannot send a port message.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator was preparing to send configuration data to
the driver, but encountered an error while trying to send the port
message (“Cause” = 32-bit status from the call to send_msg).