NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 18 405
PCI LAPBMUX Link Error Messages
SDI Driver Specific Status Values
subsystem.
1220 CLAS0001 MESSAGE: No adapter card found on specified PCI bus.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator attempted to create a new instance of the link
driver, but encountered an error which was not one of the legal errors
the configurator was able to handle (“Cause” = 32-bit status from the
call to io_configure).
ACTION: The module configurator cleaned up and returned an error to
the subsystem.
Verify the path in NMCONFIG is correct and complete, and matches
the path where a supported WAN ACC Sync MUX adapter card is
installed in your computer backplane. A diagram of the backplane slot
paths, often found in the rear of your system near the backplane, may
help you. You can also try an offline diagnostic utility such as MAPPER,
or an online utility such as SYSMAP, to precisely determine your
hardware configuration. If necessary, change NMCONFIG or contact
your Hewlett-Packard Representative for assistance in determining
paths or correcting bus hardware problems.
1240 CLAS0001 MESSAGE: No adapter card found on specified PCI bus.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator did not find an PCI bus at the hardware path
specified in NMCONFIG (“Cause” is not used here).
ACTION: The module configurator cleaned up and returned an error to
the subsystem.
Verify the path in NMCONFIG is correct and complete, and matches
the path where a supported WAN ACC Sync MUX adapter card is
installed in your computer backplane. A diagram of the backplane slot
paths, often found in the rear of your system near the backplane, may
help you. You can also try an offline diagnostic utility such as MAPPER,
or an online utility such as SYSMAP, to precisely determine your
hardware configuration. If necessary, change NMCONFIG or contact
your Hewlett-Packard Representative for assistance in determining
paths or correcting bus hardware problems.
1260 CLAS0001 MESSAGE: Bad hardware ID or path.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator did not find a supported WAN ACC Sync MUX
adapter card at the hardware path specified in NMCONFIG
(“Cause” = 32-bit hex value from a system table which holds the first
4 bytes of IODC information from the adapter card).
ACTION: The module configurator cleaned up and returned an error to
the subsystem.