NS3000/iX Error Messages Reference Manual (36923-90043)

406 Chapter18
PCI LAPBMUX Link Error Messages
SDI Driver Specific Status Values
Verify the path in NMCONFIG is correct and complete, and matches
the path where a supported WAN ACC Sync MUX adapter card is
installed in the computer backplane. Verify the Power LED is lit on that
adapter. If necessary, reseat the board or contact your Hewlett-Packard
Representative for hardware assistance.
1280 CLAS0001 MESSAGE: No adapter card found on specified PCI bus.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator did not find an PCI bus at the hardware path
specified in NMCONFIG (“Cause” is not used here).
ACTION: The module configurator cleaned up and returned an error to
the subsystem.
Verify the path in NMCONFIG is correct and complete, and matches
the path where a supported WAN ACC Sync MUX adapter card is
installed in your computer backplane. A diagram of the backplane slot
paths, often found in the rear of your system near the backplane, may
help you. You can also try an offline diagnostic utility such as MAPPER,
or an online utility such as SYSMAP, to precisely determine your
hardware configuration. If necessary, change NMCONFIG or contact
your Hewlett-Packard Representative for assistance in determining
paths or correcting bus hardware problems.
1300 CLAS0001 MESSAGE: Bad hardware ID or path.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator did not find a supported WAN ACC Sync MUX
adapter card at the hardware path specified in NMCONFIG
(“Cause” = 32-bit hex value from a system table which holds the first
4 bytes of IODC information from the adapter card).
ACTION: The module configurator cleaned up and returned an error to
the subsystem.
Verify the path in NMCONFIG is correct and complete, and matches
the path where a supported WAN ACC Sync MUX adapter card is
installed in the computer backplane. Verify the Power LED is lit on that
adapter. If necessary, reseat the board or contact your Hewlett-Packard
Representative for hardware assistance.
1320 CLAS0001 MESSAGE: Adapter card found does not match software
configuration.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator found a supported adapter card at the path
specified in NMCONFIG, but it was not the right type of card for the
link being started.
ACTION: Correct the network configuration or plug in the correct type of
adapter card, and retry the operation. The module configurator cleaned
up and returned an error to the subsystem.